LEXIBOOK Meteoclock Suntime SM1660 + ASM5 Manual De Usuario página 28

Setting the Channel
If you have purchased several remote sensors, you will need to set each sensor on a different
channel.
• Press the key found inside the battery compartment of the remote sensor to select
a channel (1 to ).
• Press this key once to switch to the 2nd channel, etc. The LED indicator will flash each time you
press this key.
• Set each remote sensor on a different channel. Channel 1 is used to receive outdoor readings
and to activate weather forecast symbols. Please place it outdoors.
Interferences
If your weather station detects other signals from neighbouring sources you will have to set your
remote sensor on a different house code (default setting = 1).
• Press the key found inside the battery compartment of the remote sensor to select a house
code (2-15). Press this key once to change the house code to 2, etc. The LED indicator will flash
each time you press this key.
• The remote sensors of each main unit must be set on the same house code.
Manual search (search for remote signals)
If a new sensor is added or a signal is lost (outdoor display will flash), you will have to manually
launch the search for each sensor.
• Press and hold down the
• A 'beep' will sound to indicate that the search function has been activated.
• Each time a remote sensor is detected a "beep" will sound.
• Press the
sensor are displayed on the screen.
28
MULTIPLE SENSOR USE
key for 3 seconds.
key and check whether the temperature and humidity readings of each