Items Supplied; Technical Data - EINHELL Bavaria BSG 40 Manual De Instrucciones

Anleitung BSG 40 7spr.
GB
instructions or recommended or listed by the tool
manufacturer. The use of any accessory or
attachment other than those recommended in
the operating instructions or catalogue may
involve a risk of injury for you personally.
21. Have repairs carried out only by a qualified
electrician
- This electric tool complies with the pertinent
safety regulations. Repairs are to be carried out
only by a qualified electrician or the user may
suffer an accident.
22. Connect up a vacuum extraction system
- If there are provisions for connecting up a
vacuum extraction system, make sure that such
a system is fitted and in use.
23. Noise
- The noise level of this electric tool is measured
in accordance with ISO 3744 and NFS 31-031
(84/537/EEC). Noise at the workplace may
exceed 85 dB(A). In this case, the operator must
wear ear-muffs or similar.
Keep these safety instructions in a safe
place.
The Multi Grinding and Engraving Set is
designed to perform drilling, grinding, deburring,
polishing, engraving, cutting, milling and
cleaning jobs on wood, metal and plastic in
model-making, workshop and household
applications. Use the tool, the power supply unit
and accessories only for those applications
described.

1. Items supplied

1 power supply unit
1 drive unit
1 plastic case
1 set of accessories

2. Technical data

Operating voltage of the drive unit:
Idle speed n0:
Clamping range:
Weight of tool (without packing):
Sound pressure level:
Sound power level:
Vibration aw:
Operating voltage of the
power supply unit:
6
24.10.2001 14:25 Uhr
3. Description
1
2
3
4
5
4. Using the tool for the first time
Fitting the various tools
Switch off the drive unit and pull out the power plug
each time before you insert a tool (and change a
tool).
1.
18 V DC
2.
0 - 22,000 min-1 3.
0.3 - 3.2 mm
4.
1.78 kg
5.
79 dB(A)
89 dB(A)
2
< 2.5 m/s
6.
230 V ~ 50 Hz
Seite 6
Power supply unit
On/Off switch
Speed regulator
Drill chuck nut
Button catch for drill chuck
Make sure that the drive unit is switched off.
Check that the mains voltage specified on the
rating plate of the power supply unit is the same
as your mains supply.
Connect the spiral cable from the drive unit to
the power supply unit. Only then should you
insert the plug of the power supply unit into a
socket-outlet.
Press the pin catch 1 and turn the drill chuck
until the pin latches in place.
Unscrew the drill chuck nut.
Select a chuck adapter sleeve to match the
accessory in question and insert it in the mount.
Loosely screw on the drill chuck nut.
Insert the tool of your choice in the chuck
adapter sleeve as far as the stop and tighten the
drill chuck nut.
All standard accessories for small drills may be
used.