Maintenance And Cleaning; Ordering Replacement Parts - EINHELL Bavaria BSG 40 Manual De Instrucciones

Anleitung BSG 40 7spr.
On/Off switch
Switch on the drive unit with the power switch. You
can set the required speed with the speed regulator.
The correct speed depends on the tool you are using
and on the material you are processing.
Tips
Exert only moderate pressure on the workpiece
and allow it to be processed at uniform speed.
You will not finish your work sooner by exerting
heavy pressure. On the contrary, heavy
pressure will cause the drive unit to slow down
or stop and will overload the motor.
For your own safety, use a vise or screw clamp
to secure small workpieces.
Directions for use
With small milling cutters / grinding pins: Use a
high speed.
With large milling cutters / grinding pins: Use a
low speed.
Precision work / engraving: Hold the drive unit
like a pen.
Rough work with the wire brush: Hold the drive
unit like a hammer.

5. Maintenance and cleaning

To prolong the working life of your tool you should
always clean it carefully after use. Do not use
solvents for cleaning purposes.
Caution!
Never clean the product under flowing water, and
particularly not at high pressure. Risk of injury to
persons and damage to property!
6. Accessories
Cut-off wheels: For the cutting of metals and
plastics. Mount the cut-off
wheel on the clamping
spindle. To do so, use the
screwdriver supplied.
Diamond ball head: For the engraving of glass and
metal for decoration and
identification purposes.
Grinding pins: Available in a variety of
grinding head shapes. For the
grinding and deburring of
metal and plastic.
Metal routers: For universal use on soft and
hard metals, wood and plastic.
24.10.2001 14:25 Uhr
Brush:
HSS bit:
Plastic brush:
Grinding wheel: For the cleaning and sharpening
Collet chucks:
Polishing felt:
Brass brush:

7. Ordering replacement parts

Please provide the following information when
ordering replacement parts:
1.
2.
3.
4.
Description of
replacement part
Power supply unit
Drive unit
Set of accessories, complete
Set of collect chucks, complete
Drill chuck nut
Seite 7
For the engraving of nonferrous
metal, the deburring and widening
of bore holes, precision carving
work, lino cuts, the machining of
plastics and printed circuitboards,
and the removal of rust from
places which arehard to reach.
For the removal of stubborn dirt.
For drilling in nonferrous metal,
wood, plastic and printed circuit-
boards.
For the cleaning, polishing and
removal of rust from metal
surfaces.
of knives and tools. Mount the
grinding wheel on the clamping
spindle.
To match the various tools
supplied in the set.
For the polishing of brass, tin,
copper, etc.. Can also be used
together with polishing paste.
For the gentle cleaning and
polishing of nonferrous metals.
For the texturing of soft wood.
Type of appliance: BSG 40
Article number of the appliance: 44.191.51
ID number of the appliance: 01010
Description and number of the replacement part
required
GB
Replacement
art number
44.191.50.01
44.191.50.02
44.191.50.03
44.191.50.04
44.191.50.05
7