Switch Off The Relays (Manually); Replace The Fuse - TechGrow Ballast Connect Manual De Usuario

12:01:00 08-01-2015
Off 23:30 On 11:00
Current 18.6A
Temp 21.6C
When the lights are off, you will see the next "On" time
and then the "Off" time.
02:00:00 09-01-2015
On 11:00 Off 22:30
Current 18.6A
Temp 21.6C

5.14 Switch off the relays (MANUALLY)

If you want to switch off all relays, because you want to
change plugs, go through the following steps:
You are in the main screen.
14:12:35 08-01-2015
No timer set!
Current 18.6A
Temp 21.6C
Press the PTK for at least 6 seconds.
Set clock
Set Timers
Set temperature
=> >> NEXT >>
Select >> NEXT >>.
=> Maintenance mode
System settings 1
System settings 2
>> HOME <<
Select "Maintenance mode" and press the PTK.
From this moment on all relays will be switched off one
by one and the LEDs (L1-L6) will go off one by one.
______________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
Maintenance mode
Relays will turn off
one by one
Push 3x to exit
When all relays are switched off, it is safe to change
plugs.
Only when all plugs are plugged in, you press the PTK 3x
to switch all relays back on.
If you change plugs when the relays are on, the
relays will be damaged. However, no guarantee is
given on the relays!
After switching on the relays you automatically return to
the main screen.

6. Replace the fuse

If the Ballast Connect is overloaded or in the event of a
short circuit, the internal fuse (2 x 15A) will break.
The fuse holders are located next to the sockets at the
front of the Ballast Connect. To replace the fuse(s) go
through the following steps:
1. Press the black fuse holder slightly with a
screwdriver and turn it a quarter of a turn
counterclockwise.
2. Remove the fuse holder.
3. Remove the fuse.
4. Insert a new 15 amp fuse.
5. Reinstall the fuse holder in the housing of the Ballast
Connect.
6. Then press the fuse holder again with a screwdriver
and tighten it by turning it a quarter turn clockwise.
Your Ballast Connect is ready for use again.
22