Fuse; Mounting Bracket; X 16 Mm Self-Tapping Screw; M4 X 6 Mm Hex-Headed Screw With Washer - Kenwood NX-5000 Serie Guia Del Usuario

4 Mount the microphone hanger in a location where it will be within easy
reach of the user.
• The microphone and microphone cable should be mounted in a place where
they will not interfere with the safe operation of the vehicle.
When replacing the fuse in the DC power cable, be sure to replace it with a fuse of the same
value. Never replace a fuse with one that is rated with a higher value.

Spring washer

M4 x 6 mm
hex-headed screw with
washer
RF antenna connector
Power input connector
DC power cable
■ Using the microSD memory card
To install a microSD memory card on this transceiver, please consult your
dealer.
• microSD memory cards (Class 2 or higher) and microSDHC memory cards (Class 2
or higher) can be used.
• SDXC memory cards cannot be used.
• This transceiver is not guaranteed to operate with all microSD memory cards.
(Operations are confi rmed on memory cards for the following brands:
SanDisk, TOSHIBA and Panasonic.)
Compensation Disclaimer
Data stored on the microSD memory card may be altered or lost due to problems with this
transceiver. We do not accept liability in respect of the data stored on your microSD memory
card, failure to save the data properly, loss of data, and any direct or indirect damages.

Flat washer

5 x 16 mm Self-tapping screw

Ignition sense
cable
External
speaker jack
Black (–) cable
Red (+) cable
GPS antenna connector
for KRA-40

Fuse

Microphone

Mounting bracket

12 V vehicle
battery
7