Dolmar MS-246.4 U Manual De Instrucciones página 18

Ocultar thumbs Ver también para MS-246.4 U:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Replacing the nylon cord
– First, stop the engine.
– Press on the housing latches inward to lift off the cover, then remove the
spool.
– Hook the center of new nylon cord into the notch in the center of the spool,
with one end of the cord extending about 80 mm (3 - 1/8") more than the
other.
Then wind both ends firmly around the spool in the direction of the head
rotation (left-hand direction indicated by LH and right-hand direction by RH on
the side of the spool).
– Wind all but about 100 mm (3 - 15/16") of the cords, leaving the ends
temporarily hooked through a notch on the side of the spool.
– Mount the spool in the housing so that the grooves and protrusions on the
spool match up with those in the housing. Keep the side with letters on
the spool visible on the top. Now, unhook the ends of the cord from their
temporary position and feed the cords through the eyelets to come out of the
housing.
– Align the protrusion on the underside of the cover with the slots of the
eyelets.
Then push cover firmly onto the housing to secure it.
Press
Eyelets
1
Cover
Latches
Press
Spool
80 mm (3 - 1/8")
For left hand rotation
Spool
100 mm (3 - 15/16")
Notches
Cover
Protrusion
Slot of eyelet

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ms-246.4 ueMs-246.4 cMs-246.4 ce

Tabla de contenido