Medistrom Pilot-12 Lite Manual Del Usuario página 7

STEP 2 – Connecting Pilot-12 Lite to PAP Device
Stand-by Mode
If the PAP device has been connected but not used within 10 min (or the PAP device is
turned off for 10 min), the Pilot-12 Lite will go into Stand-by Mode to conserve power.
To wake the Pilot-12 Lite press the Multi Function Button.
Charging Pilot-12 Lite
Follow STEP 1 above. Charge times for the Pilot-12 Lite via the Phillips Respironics
System One S60 or DreamStation AC adapter is approximately 2-3 hours. Charge time
via other compatible power adapters may vary.
Using Pilot-12 Lite as a Portable Battery with a compatible PAP device
Follow STEP 2 above. Run times will vary based on prescribed pressure, patient
breathing pattern, mask seal, use of any additional features or attachments such as
pressure relief, heated humidifier and heated tubing.
NOTE: For optimal run times while using your Pilot-12 Lite with a compatible PAP
device please disable and/or detach any humidifiers and heated tubing.
ATTENTION! Mask leaks or high PAP pressures can greatly decrease run times.
• Capacity: 95Wh
• Cell Type: LG Industrial grade genuine rechargeable lithium ion cells
• Rated Input: 12V, 60W(NORMAL) 80W(MAX)
• Rated Output: DC 12V, 6.5A
• USB Out: 5V, 2.5A
• Life Span: Over 500 full charge/discharge cycles
• Case: Aluminum
• Dimensions: 17cm x 9cm x 2cm, Weight 1.3lbs
• Power Gauge: 4 stage Charge Level Indicator Lights
• Recharge time: 2-3 hours via Respironics DreamStation AC Adapter
(charging via other compatible adapters may be longer)
Section 1.7 Pilot-12 Lite Specifications
Plug the L-shaped yellow tipped
end of the DC Out Cable for Phillips
Respironics DreamStation into the
DC Out Port of your Pilot-12 Lite and
plug the other black tipped circular
end into the power connector port of
Respironics DreamStation PAP Device.
Once the Pilot-12 Lite is connected
to your PAP device, the Charge Level
Indicator Lights will turn on briefly and
then the On Indicator Light will turn
solid blue. At this point your PAP device
will show that it is receiving power. If
your PAP device is not receiving power,
please check the cable connections
and press the Multi Function Button.
7