sylvac Ul 4 Serie Modo De Empleo página 11

9. Extinction
The instrument goes automatically into stand-by if not used for 20 minutes,
unless Auto OFF mode has been turned off (see Chap. 4, advanced functions)
Stand-by mode can be forced by a prolonged press (> 2 sec) on
In stand-by mode, the value of the origin is retained by the sensor (SIS mode),
and the instrument automatically restarts with any movement of the measure-
ment probe, RS command, Bluetooth
The instrument can be switched off completely for a long period of non-use,
but this will necessitate a zero reset on restart (the origin will be lost) :
- Prolonged press (>4s) on :
10. Re-initialising the instrument
The initial instrument settings can be restored at any time by a prolonged press
(>4 sec) simultaneously on
Nevertheless the instrument retains its configuration settings (units and resolution).
11. Personalising the instrument
Access to the functions of your instrument can be personalised, for more infor-
mation see manufacturer's website (requires you to connect your instrument
via a Proximity RS/USB cable).
Possibilities:
- De-activate or active the required functions
- Modify access to the advanced functions (direct access)
request or press of a button.
®
SET
and until the message rESEt is displayed.
MODE
SET
11
SET
>4s
E
SET
SET
>2s