Dometic CS 160 Manual Del Usuario página 8

installation
Please follow these instructions:
• For best performance, air needs to circulate free-
ly over the cooling unit behind the wine cellar.
• The free-standing design of the cellar means that
it should stand at least 25 mm (1") from the rear
and side walls.
• Allow a clearance of at least 100 mm (4") above
the wine cellar.
Distance
bar
• Note that it must be possible to open the wine
cellar door at least 90° to allow the sliding
shelves to be pulled out.
1. Remove the transport pallet on which your
wine cellar rests.
2. Adjust the feet to allow a 30 mm (1.2")
clearance under the wine cellar and verify
that it stands in a vertical position in both
directions. If necessary, use a spirit level.
3. Attach the distance bar using the two
screws at the top back on each side of the
cellar. The bar ensures the correct distance
to the wall behind.
Distance
Wall
bar
25 mm (1")
Rear
25 mm (1")
Wall
30 mm (1.2")
4. For optimum performance, please place
your wine cellar far away from any source
of heat, e.g. radiator, cooker or intense
sunlight.
5. Check that the charcoal filter is in place at
the top left corner inside the wine cellar.
6. Fit the door handle to the door, see
Appendix B.
7. Attach the drip tray on the back. The
screws are already attached at the back.
- 8 -