Connect The Cable To The Alarm Assembly; Install The Alarm Assembly - Schlage Sense Guia De Instalacion

Cerradura inteligente
Ocultar thumbs Ver también para Sense:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9b Connect the cable to the Alarm Assembly.
»
Locate the screws in step 9d before beginning this step so they will be handy
when you need them.
9c Install the Alarm Assembly.
1. Align the tab with the notch as shown.
2. Route the cable into the channel.
3. Then slide the Alarm Assembly toward the door.
Route the cable into
the channel to avoid
crimping the cable.
10
Align tab with
notch.
The connector fits only one
way. Match the dot on the
connector with the dot on the
circuit board.
IMPORTANT!
Check that tab is
aligned with notch.
If not aligned, you
may have to remove
the whole lock and
start over.

Publicidad

Tabla de contenido
loading

Tabla de contenido