Install The Battery Cover; Set Up The Lock; Test The Lock; Extend The Bolt (Lock) Using The Inside Thumbturn - Schlage Sense Guia De Instalacion

Cerradura inteligente
Ocultar thumbs Ver también para Sense:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10b Install the battery cover.
11

Set up the Lock.

1. Open the door if it is not already open.
2. Press the Outside Schlage Button.
3. Enter one of the default access codes into the
lock (see label shown in step 6
on page 5).
4. The lock will perform a setup routine. Wait
until the bolt stops moving before continuing.
»
If the Touchscreen did not light up during
this step, you may have a power problem.
Install fresh batteries and make sure the
battery wires are connected (see step
10a on page 11). If that does not help,
make sure the cable is connected and is not
crimped (see step 9b on page 10).
12

Test the Lock.

CAUTION
Keep the key with you during
testing to avoid being locked out!
12a Extend the bolt (lock) using the inside thumbturn.
1. Close the door.
2. Rotate the thumbturn toward the door jamb to
extend the bolt.
Was this operation smooth?
YES
Continue to
step 12b.
12
NO
You may need to adjust your
door/frame. Continue to step
12b for further testing, or go to
answers.schlage.com and watch
the video Proper Alignment of
Door and Frame for a Smoothly
Operating Lock for adjustment
instructions.
Speaker Hole
DO NOT install screw!
»
For complete information about
programming and light/beep patterns,
see the Manual Programming Guide
and Troubleshooting sections in the
User Guide.

Publicidad

Tabla de contenido
loading

Tabla de contenido