Test The Lock; Product Support - Schlage Control BE467F Manual Del Usaurio

3b Install the inside assembly on the inside of the door.
Bolt must remain retracted!
L
Guide the tailpiece
into the slot.
3c Secure the inside assembly with two screws.
If the screw holes are blocked by the cam, see step 3a.
L
3d Connect the cable to the inside assembly.
3e Install the batteries.
4
Route the cable
through the hole in
the inside assembly.
Actual Size (2)
Red wire
The connector fits only one
way. DO NOT FORCE!
3f Install the inside cover.
Align the slot with
the tailpiece.
3g Secure the inside cover with two screws.
4

Test the Lock

4a Extend and then retract the bolt using the inside bolt
throw.
Bolt should extend and
retract smoothly.
Outside bolt throw should spin freely until a valid credential is
L
presented.
5
Set up the lock.
Continue to www.schlage.com to download the Schlage Control
Smart Locks User Guide.

Product Support

1-800-847-1864
Thumbturn should
be pointed towards
hinges, with longer
side on top.
Actual Size (2)
www.allegion.com/us