Monti MBX Die Blaster Instrucciones De Servicio página 21

® ®
MBX
Die Blaster
Correct
direction of operation
If the tool does not work correctly, check the following:
Are you using a suitable
Æ
Is the tool operating at the stipulated speed? – Problems with the tool, see section 9, Troubleshooting.
Æ
MBX
Are you using an
Æ
direction (see section 6, Placing in operation, Fig. 2).
®
Is the MBX accelerator bar showing signs of wear? Check MBX
Æ
approx. 45° or renew.
Less pressure = longer service life and
Holding machine
®
MBX belt for the surface to be machined? – Use the most suitable MBX
®
belt with the wrong direction of travel? – Fit the brush belt such that is runs in the correct
higher performance
®
accelerator bar. In case of wear, rotate by
Operating instructions
GB
®
belt.
21