Technical Data; Lubrication / Servicing - Monti MBX Die Blaster Instrucciones De Servicio

Operating instructions
GB
7.

Technical data

®
Technical data: MBX
Technical data: Pressure regulator
Noise figures
Vibration figures
7.1

Lubrication / servicing

Lubrication
If the tool is new, ensure the compressed air motor is lubricated prior to operation. If a series lubrication device is not
used, add a few drops of light oil to the compressed air connection daily. Correct lubrication will ensure longer tool
service life.
22
®
Die Blaster
Air consumption ............................................................................400 litre/min. (CFM) 14.2
Compressed air connection ........................................................................................R 1/4"
Necessary hose size.................................................................................. 3/8" ID (9.5 mm)
Weight .........................................................................................................................1.1 kg
Max. inlet pressure ..................................................................................... 18 bar (170 psi)
Compressed air connection ....................................................................................... G 1/4"
Weight ............................................................................................................................90 g
No-load (not under load)
With 11 mm belt
The A-weighted noise level of the tool is typically:
sound pressure level LPA=84 dB (A); sound power level LWA=89.43 dB (A).
Wear hearing protection!
Belt
®
MBX Die Blaster
Flow pressure
bar (psi)
5.2 (75)
5.2 (75)
Width
®
belt 11 mm
MBX
Speed
revs/min.
2600 ± 5 %
2100 ± 5 %
Motor
a / m/s²
hw
1.45
® ®
Die Blaster