Generac OneWASH Manual Del Operador página 24

Operation
1. Turn the ON/OFF switch to the "ON" position
(Figure 5-2).
ON/OFF SWITCH
Figure 5-2. ON/OFF Switch
2. Rotate pressure control knob to the position shown
on "Start" decal (Item #2) (Figure 5-3).
,
Figure 5-3. Power Dial
Choke the engine by slowly pulling out on the choke
knob until it stops in the "ON" position (Figure 5-4).
Hearing Protection Recommended.
NOTE:
For a warm engine, push the choke knob down until
it stops in the "OFF" position (Figure 5-4),
Figure 5-4. Choke Knob
,
5.
Secure unit from movement when pulling recoil.
When starting the engine, grasp starter grip handle
(Figure 5-5) and pull slowly until you feel some resis-
tance. Then pull rapidly to start engine.
STARTER
GRIP
Figure 5-5. Starting the Engine
,
7.
Return starter grip handle slowly. DO NOT let rope
"snap back" against holder.
When engine starts, slowly push the choke knob in to
the "OFF" position as engine warms. If engine falters,
pull choke knob out to the "ON" position, then push in
to the "OFF" position (Figure 5-6).
20 OneWASH
TM
Power Washer