Reliminary Heck Of; Installing The Ups; Teps To Be Aken To - GMP 10 kVA Manual Del Usario

P C
RELIMINARY HECK OF
Having opened the package, start by checking the contents.
Metal slides, Guarantee document, User manual,
Serial connecting cable, 4 battery fuses (to be
inserted in the "SWBATT" fuse holders), Front door
key
I UPS
NSTALLING THE
When installing the equipment, the following points should be considered:
 The wheels are to be used exclusively for fine positioning, and thus for small distances only.
 The plastic parts and the door are not to be used for gripping or pushing the UPS.
 Sufficient space should be left in front of the equipment for it to be turned on/off and maintenance operations to be
performed on it ( ≥ 1.5 mt )
 The rear part of the UPS should be set at least 30 cm from the wall, to enable the air blown by the ventilation fans to
flow away correctly
 No objects should be left on its top surface
Having set the equipment in position, secure it by engaging the brake rod (see "Front Views of the UPS" point 8) situated below
the connecting terminals.
In seismic areas or for mobile systems, the brackets used to fasten the unit to the pallet (ramps) can be reused to anchor the
UPS to the floor (see the figure below). In normal conditions, the brackets are not necessary.
S T
TEPS TO BE AKEN TO
The operations indicated below are to be performed with the UPS disconnected from the mains powers,
turned off and with all the switches and fuse holders of the equipment open.
Follow the instructions provided below to open the UPS:
 Open the door
 Remove the terminal and switches cover (see "Views of the UPS" ref. 7)
Having completed the installation operations inside the equipment, replace the terminal cover and close the door.
C
ONTENTS
UPS
B
AND THE ATTERY
G A
AIN CCESS TO THE
Metal slides, Guarantee document, 4 battery fuses (to be
inserted in the "SWBATT" fuse holders), Front door key
B
OX
T
ERMINALS OF THE
BATTERY BOX (optional)
UPS / B
ATTERY
B
OX