More About Your Brewer; Additional Information - Bunn VELOCITY Brew NHS Instrucciones De Uso Y Cuidados

More AbouT Your brewer

• Brewer is designed to be plugged in at all times, except during initial setup or
when cleaning.
• The stainless steel hot water tank is designed to keep water at the proper
brewing temperature at all times. During a brew cycle, the newest water added
to the tank is heated to proper brewing temperature and held until needed.
• Use vacation switch to completely shut off all electrical components when
brewer will not be used for 3 or more days. Safety features built into the
BUNN Velocity Brew make daily use of the vacation switch unnecessar y.
• If brewer is shut off or unplugged for an ex tended period of time, allow water
to heat to the proper temperature before using (about 15 minutes or until the
heating sound stops).
• If brewer has been shut off and drained of all water, follow Initial Setup (page 4)
before brewing again. Improper setup will result in permanent damage to your
brewer and void the limited warranty.
• NHS, GR , BX – Brewed coffee f lows into a glass carafe and is kept at ser ving
temperature by the porcelain carafe warmer. Warmer is controlled by the on/off
switch at the front of the brewer. NOTE: The warmer switch controls only the
carafe warmer. It is NOT the vacation switch.
• ST, BT – Brewed coffee f lows into an unheated thermal carafe. The double wall
stainless steel construction holds coffee at ser ving temperature for about 2
hours at maximum f lavor. Pre-heating (instructions on page 6) carafe with hot
water increases the time coffee stays warm.
• When brewer is not in operation, the spin or f lip lid should be closed. If lid is lef t
open, water can drip from the sprayhead when cold water is poured in.
• Hot water for cooking may be dispensed through the brewer when there are no
coffee grounds in the f ilter basket. Use caution when dispensing hot water from
the brewer. The water is approximately 50°F hotter than a hot water faucet.
• If the sprayhead becomes loose and needs to be retightened with your
f inger tips, make sure it has cooled suff iciently to avoid burning your f ingers.
HoT wATer TANK
GLASS AND THerMAL cAr AfeS

ADDITIoNAL INforMATIoN

9