Completion - Subzero PRO 48 Guia De Instalacion

INSTALLATION

Completion

Install the grille assembly and check for proper fit. Recon-
nect the network cable. Refer to page 6. Attach the network
cable to the grille using cable ties provided.
Reinstall the drain pan and verify it is in the proper position.
Install the kickplate using screws to attach it to brackets on
the inside of each roller base. Refer to the illustration below.
The kickplate must be removable for service. The floor
cannot interfere with removal.
Install leg covers. Remove paper backing and press into
position.
Turn power on by touching POWER on the control panel.
Kickplate installation.
|
10 Sub-Zero Customer Care 800.222.7820
WATER FILTER BYPASS
If the water filtration system will not be utilized, it can be
placed in water filter bypass mode by removing the water
filter. Refer to the illustration below. Follow these steps to
remove the water filter:
Pull out on the bottom edge of the grille assembly and
1
tilt the grille frame upward.
To remove the cartridge, rotate the cartridge counter-
2
clockwise one-quarter turn and pull out. Refer to the
illustration below.
Open grille.
WATER FILTER
Water filter removal.