Fresh Food Features - JENN-AIR ChillKeeper Manual Del Usario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

F
F
RESH
Shelves
CAUTION
To avoid personal injury or property damage,
observe the following:
• Never attempt to adjust a shelf that is loaded with
food, except in the case of the Elevator
• Confirm shelf is secure before placing items on
shelf.
• Handle tempered glass shelves carefully. Shelves
may break suddenly if nicked, scratched, or
exposed to sudden temperature change.
Your refrigerator has either Spill-Catcher™ or non-
sealed shelves. Spill-Catcher™ shelves have a spill
retainer edge which allows for easier cleanup and
some are equipped with a slide out feature. To slide out
(select models), grasp the front of the shelf and pull
forward. Push in the shelf to return to the original
position.
To Remove a Shelf:
• Slightly tilt up the
front and lift up the
rear of the shelf, then
pull the shelf straight
out.
To Lock the Shelf Into Another Position:
• Tilt up the front edge of the shelf.
• Insert the hooks into the desired frame openings and
let the shelf settle into place.
• Be sure the shelf is securely locked at the rear.
The Crisper Top serves as the lower fresh food shelf.
To Remove the Crisper Top:
• Place hand under the frame to push up the glass. Lift
glass out.
To Install:
• Repeat above instructions in reverse order.
Elevator™ Shelf
(select models)
The Elevator™ Shelf is equipped with a spill-retaining
edge and the EasyGlide™ slide-out feature. It can be
adjusted up or down without unloading.
F
OOD
EATURES
Shelf.
TM
To Slide Out Elevator™ Shelf:
• Grasp the front of the shelf and pull forward.
• Push the shelf in to return to original position.
To Adjust the Elevator™ Shelf:
• Pull out the knob on the crank handle.
• Rotate the crank clockwise to raise the shelf, and
counterclockwise to lower the height of the shelf.
To Remove Elevator™ Shelf:
• Completely unload the shelf and pull the shelf
forward.
• Pull until the shelf stops.
• Press up on the tabs located underneath its outside
edges and continue pulling forward until the shelf is
clear of the frame.
To Replace Elevator™ Shelf:
• Align the shelf to the frame and push it all the way
back. It is not necessary to press up on the tabs for
reinstallation.
In ordinary use, the Elevator™ Shelf frame assembly
does NOT require removal. Though unlikely, and not
recommended, the correct removal procedure is as
follows:
To Remove Frame Assembly:
• Unload the shelf completely.
• Slide the shelf forward about 2" and manually move
the two rear latches toward the shelf center.
• While supporting the entire shelf and frame from
underneath, lift slightly and rotate the assembly
approximately 30° to allow the rear mechanism to
clear the vertical rear side rails.
• The entire assembly can then be moved forward
and clear of the refrigerator compartment.
To Reinstall Frame Assembly:
• Reverse the removal procedure. Be sure the shelf
is in a level position. When the sliding shelf is
pushed to the rear, it will reposition the rear latches
to their correct operating position.
(style may vary)
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ukf8001axxUkf8001axx750

Tabla de contenido