BEBE CONFORT Opal Manual Del Usuario página 26

• Ensure that the straps under the stomach lie as low as
possible, to properly support the pelvis.
• The temperature inside a vehicle may become very
high, particularly after a long period of exposure to the
sun. It is strongly recommended, under such conditions,
to cover the seat of the car with a piece of material or
something equivalent to prevent the harness fixings,
and in particular the metal parts, from becoming hot
and burning the child.
Bébé-Confort Opal car use
• This device should be used only on approved vehicles
equipped with 3 point/static/inertia reel seat-belts that
are approved in accordance with EEC/UN regulation N°
16 or other equivalent standard.
• Back to the road, do not use this car seat rearward
facing, where front impact AIRBAGS are fitted and
armed. You may be able to deactivate it (see instruction
book supplied with your vehicle). If so, and you are able
to deactivate the airbag, you can use it facing forwards
in your vehicle.
• Facing forward, the child seat must be placed on the
rear seat of the vehicle or exceptionally on the front seat
depending on the current legislation in the country of
use.
• This child restraint is effective only if the instructions
for use are respected.
• Always fasten the child restraint even when the child
is not sitting in it.
• The user must always check that any luggage and
other objects likely to cause injury to the occupant of
the car seat in the case of impact are properly secured.
26
EN
• Never place heavy objects on the rear parcel shelf, to
avoid the danger of projectiles in the event of an
accident.
• The rigid parts and the plastic sections of a child
restraint device should be positioned and installed in
such a way that they cannot, when the vehicle is being
used under normal conditions, become trapped under a
moving seat
or in the vehicle door.
• Always check that no part of the seat or the harness is
trapped under a seat or in the vehicle door.
• It is essential that the car seat be replaced after an
accident.
• Never modify the construction or the materials of the
car seat and the seat belt without consulting the
manufacturer.
• Do not use the child restraint device without the cover.
Do not replace the seat cover with a cover other than
that recommended by the manufacturer, because it will
have a direct effect on the functioning of the child
restraint.
• Folding seats must always be locked in place
• After purchasing, install the seat in your vehicle. If you
encounter any installation problems due to the length of
the vehicle seat belt, contact your distributor immediate-
ly (prior to use).
• If in any doubt about the correct installation or use of
the system, the user is advised to contact the distributor
or the manufacturer of the child restraining device
system.