Features - Snap-On FJ200 Manual Del Propietário

The Snap-on FJ200 2 Ton Capacity Service
®
Jack was designed specifically for the profession-
al technician. The Model FJ200 is assembled in
the USA and includes Patents and Patent Pend-
ing features that provide exceptional performance
and reliability.
CHASSIS
The exclusive Snap-on jack chassis is made of
steel plate with re-enforcing upper and lower
flanges for added strength. Low lift height and
extended low profile frame provide access under
low ground clearance vehicles. High lift height for
positioning vehicles on frame straightening racks
or alignment systems. Large patented saddle
for load positioning, locks into saddle base and
is easily removed for installation of other saddle
adapters.
HYDRAULIC POWER UNIT
The two pump piston power unit raises the jack's
saddle to the load quickly to save work time. Spring
loaded pump pistons are in constant contact with
the handle yoke to prevent handle from falling. An
integrated filtration system prohibits contaminants
from entering hydraulic valves and high pressure
components. Self-contained non-vented reservoir
prevents fluid leaks. High performance seals and
hydraulic fluid provide longer life. Load-limiting
and bypass valves prevent use beyond working
capacity and prevent over-extension of the ram.
MANEUVERABILITY
Wide track front wheels with crowned rolling
surface and grease fittings provide smooth
rotation. Wheels secured to axles by way of
locknuts. Two rear swivel caster assemblies are
constructed with dual bearings and lubricated
axles for minimal axial and radial play.
SMOOTH OPERATION
Fully factory lubed with grease fittings in the lift
arm and two fittings in the handle yoke to access
pivot pins. Handle yoke includes quick-lock spring
FJ200

FEATURES

knob for easy handle insertion or removal. Heavy
duty release valve assembly with built-in stop pre-
vents accidental removal and provides easy rota-
tion. Long one-piece handle for easier pumping
and positioning of jack under vehicle.
ADDITIONAL INFORMATION:
• Low height of 3.5" to fit easily under a
• Lift arm is contoured to allow clearance
with vehicle's rocker panel.
• Maximum lifting height of 23.34".
• Dual pump pistons for speed to reach
• Premium U-cup seals on pumps and ram
• Removable saddle with rubber pad.
• Professional, one-piece handle design.
• Grease fittings in lift arm pivot, handle yoke
• Front wheels have a nut and shoulder
• Special Snap-on high-performance hydraulic
• Internal filtration with magnet in pump
• Powder coated finish for durability.
5
variety of vehicles.
service height quickly.
pistons for long life.
pivot and front wheels.
design for positive retention.
oil for extreme temperatures and reduced
wear.
reservoir to maintain oil cleanliness.
Rev. 09/09/14