Snap-On FJ200 Manual Del Propietário página 9

2. Check tightening of all hardware.
3. Check rotation of front wheels and rear caster
wheels.
4. Use compressed air to remove any dust or
dirt from the jack.
TYPE OF OIL
In the event the jack's hydraulic reservoir
requires additional fluid, use only a non-detergent
hydraulic jack oil with 22 viscosity rating. Using
any other fluid will cause damage to the seals
and void the warranty. In order to ensure proper
performance, the correct fluid level must be
maintained in the reservoir. The proper fluid level
is checked when the jack's lift arm is all the way
down. The fluid level should be no higher than the
top of the internal cylinder as shown in Figure 2.
FLUID LEVEL
Figure 2
FJ200
MAINTENANCE
FILL SCREW
CYLINDER
RESERVOIR TUBE
9 Rev. 09/09/14