STEINEL PROFESSIONAL HG 2620 E Manual De Instrucciones página 5

Programming mode [P]
Four programs are factory-set for the most common types of work. Press button "P" for programming mode.
Number 1 is displayed for programme 1. Continuing to press the programme button will take you to programs
2-4. Pressing the button again will return the tool to normal operation.
Preset programs
Program Temperature °F (°C) Air cfm
1 480 °F (250°C) 7 cfm
2 660 °F (350 °C) 9 cfm
3 840 °F (450 °C) 11 cfm
1020 °F (550 °C) 11 cfm
4
Memory function [S]
The values selected for the four programs can be changed and memorised at any time. To do this, first press
the program button "P" 11 until the display shows the program you wish to change. Set the temperature
and airflow rate you require. Memory symbol on the LCD flashes to indicate that the user program selected
has been changed. To memorise this setting in the user program selected, press and hold down the program
selector button. The memory symbol continues to flash for approx. 2 sec. The settings entered are saved
once the memory symbol stays on all the time. To return to normal operation, press the program button until
the program symbol disappears from the display.
English
- 8 -
Maintenance
a
a
Repair
If the power cord is damaged, it can easily be changed without opening the casing.
1. Undo screw and pull off cover cap
a .
d
2. Release cable grip
.
b
3. Undo mains terminals
c .
4. Pull out cable e .
5. Insert new cable and secure in reverse order (1. Firmly screw down mains terminals etc.).
Changing the heating element
The plug-in heating element in the HG 2620 E can be changed in a matter of seconds.
1. 2.
3. 4.
Important! Disconnect tool from power supply.
1. Undo guard sleeve screws and remove guard sleeve (Fig. 1).
2. Undo 4 screws at the end of the hot air outlet nozzle and detach heating element.
3. Replace the heating element with a new one and firmly screw heating element into place (Fig. 3).
4. Firmly screw guard sleeve back on (Fig. 4).
English
3
Fine dust filter
The HG 2620 E has an integrated fine
dust filter 3 . To clean it (with com-
pressed air), undo screws (a), take off
cover and remove filter.
Changing the power cord 14
Important! Disconnect tool from power
supply. Let have electrical repairs only
be executed by fully trained licensed
electricians.
1. 2.
3. 4.
- 9 -