6.4 Screwdriving
CAUTION
Risk of injury by damaged workpieces! Screws or workpiece can be
damaged if torque is too high. This presents a risk of injury.
▶ Make sure that screws and workpiece are suitable for the torque produced
by the tool.
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Use the torque selector switch to set the desired torque. → page 13
6.5 Switching off
▶ Release the control switch.
6.6 Removing the accessory tool
SID 14A
SID 22A
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when using the power tool and when changing
accessory tools.
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the chuck ring forward and hold it in this position.
3. Pull the accessory tool out of the chuck.
4. Release the chuck ring.
6.7 Removing the accessory tool
SIW 14A
SIW 22A
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when using the power tool and when changing
accessory tools.
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the accessory tool off the square drive.
14
English
7
8
2153700
*2153700*