Correct Operation; 10-1.1 Cleaning The Waste Bins - Dulevo 700 EH Manual De Uso Y Mantenimiento

SWEEPER 700 EH - 700 SH - 900 EH - 900 SH

10-1 CORRECT OPERATION

After you have become conversant with the operations required to start the machine, you can actually start using
the sweeper To obtain the best results, it is always wise to take a few precautions.
These will help you get the best from your machine and reduce damage to aminimum.
In particular:
- Do not use the machine to clean up wires, ropes or straps or soak up water and other liquids.
- When using the machine on light but bulky material (sheets of paper, leaves, etc); raise the front part of the
machine by pressing down the handlebar so that the machine can tackle the rubbish.
- Operate the filter shaker at the end of your work.
- Make sure the centre brush is correctly regulated (see the section on adjusting the centre brush).
WARNING DANGER:
petrol is highly inflammable. Keep your fuel in containers designed for the purpose. Top up your fuel tank
ONLY when the engine is off. Do not remove the fuel tank cap when the motor is running or hot. Always
fill your fuel tank in open air or in a sufficiently ventilated area. Do not smoke during this operation and
do not use naked flames.
If you spill fuel during this operation, DO NOT attempt to start the engine but wait for the vapour to
evaporate.
WARNING:
Always turn off the engine:
- before leaving the machine unattended;
- before filling the fuel tank;
- before carrying out any work on the machine.

10-1.1 CLEANING THE WASTE BINS

WARNING:
Before carrying out this operation, make sure all parts of the machine are off.
WARNING:
Wastes must be disposed of strictly in accordance to the law.
FRONT BIN
- Lift and turn the two bin locks.
- Grasp both the handle and the grip located on the front part of the bin and remove the bin by pulling it upwards.
- Empty the bin.
To put the bin back in place:
- Put the bin back in the machine from the top.
- Turn and lower the two locks.
REAR BIN
- Lift and turn the two bin locks.
- Grasp the handle and pull the bin out of the machine.
- Empty the bin.
To put the bin back in place:
- Put the bin back in the machine from the top.
- Turn and lower the two locks.
¨
2008-02
EN
39