Important Instructions - Global 246103 Manual Del Usuario

Please read all instructions before using this heater.
When using electrical appliances, basic precautions should
always be followed to reduce risk of fire, electrical shock and
injury to persons or property, including the following:
1.Read all instructions before using this heater.
2.This heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes and
curtains at least 3 ft. (0.9 meters) from the front and top of the
heater and keep them away from the sides and rear.
3.Extreme caution and reasonable supervision is necessary
when any heater is used by or near children, invalids or pets
and whenever the heater is left operating and unattended.
4. Always switch off the heater when not in use.
5. Do not operate any heater after the heater malfunctions, has
been dropped or damaged in any manner. Disconnect power
at service panel and have heater inspected by a qualified
electrician before reusing.
6. Do not use outdoors.
7. To disconnect heater, turn off power to heater circuit at main
disconnect panel.
8.Do not install less than 6 feet (1.8 m) high from the floor.
9.Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire, or
damage the heater.
Manufacturer Model
Length Inches
Height Inches
Wire Size For
Net Weight Lbs
Outlet Air Temperature
Circuit Breaker Amp
Safety Tip-Switch
Limited Warranty Years
Horizontal Unit Heater

IMPORTANT INSTRUCTIONS

Product Specifications
Model
Width Inches
Installation
Construction
Btu High
Cfm High
140°F @ Ambient Temp.
Voltage
Phase
Amps
Watts
Kilowatts
rating
Certification
NOTE: This product must be installed by a certified electrician
in accordance with local codes.
Traces of smoke or odor when unit is initiated indicates that small
amounts of oil leaked on heating coil during manufacturing. It will
evaporate quickly and should not re-occur. Make sure the appli-
ance location is well ventilated during operation. It is normal for the
unit to emit sounds when turned on for the first time.
Make sure that the room in which the appliance is located is well
ventilated during this operation.
10.To prevent a possible fire, do not block air intakes or exhaust
in any manner.
11.A heater has hot and arcing or sparking parts inside. To reduce
the risk of fire, do not use it in areas where gasoline, paint, or
flammable vapors and liquids are used or stored.
12.Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electric
shock, or injury to persons.
13. Do not install closer than 1 foot (0.3 m) from both sides and
rear of heater to any adjacent surface/wall.
High temperature, risk of fire, keep electrical
cords, drapery, furnishings, and other
combustibles at least 3 feet (0.9 m) from the
front of the heater and away from the side
246104
PU-08483
8.5
19
21
7/16
10AWG
41
Cold Rolled Steel
25,600
650
149°F @ Ambient Temp.
77°F
480
3
9
7,500
7.5
15A
No
1
UL/cUL
2
and rear.
246103
PU-10483
8.5
19
21
7/16
10AWG
41
Cold Rolled Steel
34,100
650
77°F
480
3
12
10,000
10
15A
No
1
UL/cUL
User's Manual