Important Instructions - Global 246726 Manual Del Usario

PLEASE READ ALL INSTRUCTIONS
BEFORE USING THIS HEATER
NOTE: There may be a trace of smoke or odor when unit is first
operated. Don't be alarmed. This indicates that a drop of oil fell on
the heating coil during the manufacturing process. It will quickly
evaporate and should not re-occur.
Make sure that the room in which the appliance is located is well
ventilated during this operation. It is normal for the appliance to
emit small cracking sounds when you turn it on for the first time.
Do not be alarmed.
When using electrical appliances, basic precautions should
always be followed to reduce risk of fire, electrical shock and
injury to persons or property, including the following:
1.Read all instructions before using this heater.
2.This heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes and
curtains at least 3 ft. (0.9 meters) from the front and top of the
heater and keep them away from the sides and rear.
3.Extreme caution and reasonable supervision is necessary
when any heater is used by or near children, invalids or pets
and whenever the heater is left operating and unattended.
4. Always switch off the heater when not in use.
5. Do not operate any heater after the heater malfunctions, has
been dropped or damaged in any manner. Disconnect power
at service panel and have heater inspected by a qualified
electrician before reusing.
6. Do not use outdoors.
7. To disconnect heater, turn off power to heater circuit at main
disconnect panel.
8. This heater should be installed at least 8 feet (2.4 m) from the
floor and no closer than 1 foot (0.3 m) from any adjacent
surfaces or walls. Keep at least 4.5 inches (0.12m) from the
back wall, regardless of whether the wall mount bracket is used.
PARTS OF THE HEATER
C
D
E
F
POWER
TIMER
G H I
Horizontal Downflow Unit Heater
With Remote Control

IMPORTANT INSTRUCTIONS

HIGH
LOW
J K
9.Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire, or
damage the heater.
10.To prevent a possible fire, do not block air intakes or exhaust
in any manner.
11.A heater has hot and arcing or sparking parts inside. To reduce
the risk of fire, do not use it in areas where gasoline, paint, or
flammable vapors and liquids are used or stored.
12.Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electric
shock, or injury to persons.
13. This product must be installed by a certified electrician, in
accordance with local codes.
14. For supply cables, use 8 AWG (8.3 mm2) copper wires .
15. This heater includes a visual alarm to warn that parts of the
heater are getting excessively hot. If the alarm flashes,
immediately turn the heater OFF and inspect for any objects
on or adjacent to the heater that may have blocked the airflow
or otherwise caused high temperatures to have occurred.
DO NOT OPERATE THE HEATER WITH THE ALARM FLASH-
ING. To reset the heater, switch the CIRCUIT BREAKER OFF and
wait five to ten minutes for the heater to cool down before turning
the heater on again.
16. This appliance is not intended for use by persons (including
children) with reduced physical, sensory, or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction regarding use of the appliance
by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
RISK OF FIRE, DO NOT USE AS A
RESIDENTIAL OR HOUSEHOLD
A
INSIDE
THERMOSTAT
B
WALL
THERMOSTAT
L
A. Wall Mount Bracket
B. Tilt Adjustable Knob
C. Upper Housing
D. Front Exhaust Grill
E. Louver for air direction
F. Control Panel
G. Alarm LED
H. Power Indicator
I. Timer Indicator
J. Low Indicator
K. High Indicator
L. Internal/Wall Thermostat Switch
M.ON/OFF Switch
2
User's Manual
HEATER.
OFF
ON
M
Parts List