Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FIXTURE PACKING LIST
Description
1) Housing Assembly ............................................................... 1
2) Photocontrol ........................................................................ 1
3) 5/16-18 Bolts ....................................................................... 2
4) 2" Screws* ........................................................................... 3
5) Cover Plate.......................................................................... 1
6) Wire Nuts* ........................................................................... 3
*Contained in parts packs
Mounting Hardware Included
Waterproof Supply Fittings & Conduit
and Silicone Sealant will Be Required
REQUIRED TOOLS:
1. Remove fi xture components and parts pack. Check to
ensure all parts are included. Note: Account for small parts and
destroy packing material, as these may be hazardous to children.
Note: Not suitable for use with dimmers, motion sensors or other
remote devices.
Turn OFF Power at circuit breaker box.
CAUTION: Do not rely on wall switch alone to turn off power
Fixture Mounting
Note: Hardware included for mounting to wood surfaces only.
Ensure that fi xture is mounted onto structurally sound wall surface
that will support the fi xture.
Optional Mounting Arm available (sold separately)
2. Using the template on the box, mark mounting hole
locations and drill 3/16" diameter pilot holes. See Fig. B.
3. Install two 2" Screws (4) in bottom holes, leaving about 3/8"
space under the head.
4. Intall the third 2" Screw (4) into the predrilled hole on top and
back the Screw out. This will leave the hole threaded and make
installation easier.
5. Place Fixture Housing on the two bottom Screws and install third
Screw.
6. Tighten two bottom Screws to secure fi xture.
CAUTION: WIRING AND FIXTURE OPERATION
Make sure power is turned off. Connect to 120V, 60Hz circuit only.
7. Remove knockout on back of Cover Plate (5) for
junction box/arm mounting or remove knockout on bottom of
Cover Plate for conduit mounting and feed house supply wires
through hole. Note: This fi xture is intended for use with conduit
connectors, conduit and junction box that are UL listed suitable for
wet locations and are properly installed and grounded.
8. To Ground fi xture use wire nut (6) to connect the (copper)
house supply ground wire & the bare copper fi xture ground wire.
Note: If house wiring does not include a ground wire, consult your
local electrical code for approved grounding methods.
For proper connection, place wire nut over wires
and twist clockwise until tight.
INSTALLATION INSTRUCTIONS
Quantity
Figure A
9. To Connect supply wires use wire nut (6) to connect the black
fi xture wire to the black power supply wire and the white fi xture
wire to the white (neutral) supply wire.
10. Secure Cover Plate (5) to housing with two 5/16" Bolts (3).
See Fig. A.
11. Turn on electricity at fuse or circuit breaker box and verify
success of installation.
Note: test fi xture at night or block photocell.See Trouble shooing
guide for more info.
12. Apply silicone caulking (not included) around the perimeter
of the fi xture back where it contacts the mounting surface for
moisture seal.
page 3
1) Housing Assembly
5) Cover Plate
4) 2" Screws
6) Wire Nuts
3) Bolts
Figure B
Publicidad
Tabla de contenido
