Important Warnings; Before First Use - Di4 Aspirovac Ultraforze 40V Manual Del Usuario

IMPORTANT WARNINGS

Prior to plugging in the product, check that your mains voltage is the same as the one indicated on
the product label.
The mains connection cable must not be tangled or wrapped around the product during use.
Do not pull on the connection cord in order to unplug it.
Do not use, connect or disconnect the device to the mains with your hands or feet wet.
Proceed according to the conservation and cleaning section of this manual for cleaning.
Unplug the product immediately from the mains in the event of any breakdown or damage and con-
tact an authorised Technical support service.
In order to prevent any risk of danger, do not open the device. Only qualified technical personnel from
the brand´s Official Technical support service may carry out repairs or procedures on the device.
Any incorrect use or improper handling of the product shall render the warranty null and void. Only an
authorised technical support service centre may carry out repairs on this product.
This appliance is designed exclusively for domestic use, in no case should be a commercial or indus-
trial use. In case of misuse or tampering with the product, it will be out of warranty.
Do not use the appliance to vacuum liquids (water, etc), sharp objects (pins, pins, nails, glass, etc),
incandescent objects (matches, cigarettes)
Never use the turbobrush to: Polish floors, suck (Liquids, wet or damp dust, hot ash, burning ob-
jects, such as cigarettes, matches, sharp and hard items, such us: razors, pins, thumbtacks, pieces
of glass, etc), flour, cement, plaster, printer or photocopier toner, etc.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for
the non-observance of these warnings.

BEFORE FIRST USE

1. Remove the main body of the appliance and other parts/accessories from the packaging.
2. Attach the floor brush to the main body.
3. There is a lock on bottom of suction head to fix the brush. Make sure it's locked in place for use.
4. Connect the handle to the main body using the screw included with this appliance. Assure that this
part is well fixed before to use the product.
5. Put the dust tank into the product before use the product. The appliance includes one button to
release this part in order to be cleaned.
6. Insert the battery pack in the battery compartment of main body. Assure that is completely fixed.
INSTALLATION AND REMOVAL OF ALL PARTS
Connection of floor brush and vacuum cleaner
• Assembly of floor brush component: Please place electric floor brush on the ground according to di-
rection in the drawing during connection; Floor brush connector is set in vertical limited state. Button
mechanism of floor brush takeover shrapnel is pressed, and the floor brush connector is plugged into
main body until locking sound of 'ka' is heard. Installation is completed.
• Removal of floor brush component: Button mechanism of floor brush takeover shrapnel should
be pressed with tool firstly. Then, floor brush can be removed according to direction in the drawing.
14