How To Install - Panasonic FY-3009U1 Instrucciones De Instalación Y De Funcionamiento

How to install

1. Fix the mounting plate
Mounting on concrete wall.
1. Remove mounting plate from product.
Taking the mounting plate by removing the
3 screws.
2. Firmly fix the bolts in the proper position.
· Determine the position on the wall and drill
into the wall.
· Fit the bolts into the holes.
· Fill the holes with concrete.
· Install the mounting plate and check if it's
secured when the concrete solidifies.
Notice
Distance of bolt head away from wall should
be 13 ~ 15mm.
3. Fix the mounting plate with washers, spring
washers and nuts.
CAUTION
Please use the mounting plate
provided with product to avoid the
dropping caused by insufficient
strength.
Other installation methods
Mounting on steel
hanger
M8 bolt
15mm
below
Notice
1. It's prohibited to install the product on hollow
wall, otherwise it may produce noises.
2. Conduct the necessary reinforcement,
depending on the particular condition to
avoid noise resonance and vibration.
2.Preparation before wiring
Pre-hang up the product into the bottom holes of mounting plate.
Mounting on wooden
frame
Wooden
screw
( 8×60L)
1. The inside space of ceiling should exceeding
2. Don't place the substances near the air inlet
(
Carry out this step if the distance between top
face of product and ceiling is less than 150mm.
150mm above
Mounting
Plate
Concrete
Bolt
M8×60L
13-15mm
Spring washer
Mounting plate
Mounting inside the ceiling
Partition plate
(not supply) is
installed at four
sides.
350mm above
the dimensions as indicated above to ensure
the space of air inlet, please select the larger
model if space of air inlet can't be reserved.
or outlet grille (include the grille).
It could affect the performance.
Screw
About 70mm
Wall
Washer
Nut
100mm above
Ceiling
)
Bottom holes
6