Descargar Imprimir esta página

CAMP CHEF FTG250 Manual De Instrucciones página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
• Do not use appliance until leak checked.
• If you cannot stop a gas leak, immediately close LP tank
valve and call LP gas supplier or your fire department!
WARNING
Appliance must be leak checked outdoors in well-ventilated
area, away from ignition sources such as gas fired or
electrical appliances. During leak test, keep appliance away
from open flames or sparks.
3. Check the connection between the cylinder and the regulator
with soapy water. Bubbles indicate a leak. Check that the
connection is not cross-threaded and that it is tight. Perform
another leak check. If there is still a leak, remove the
cylinder and contact the manufacturer for service or repair,
1-800-650-2433
Leak Test
4. The regulator uses a threaded fitting to attach to the stove.
It is necessary to hold the stove to make sure the fitting is
seated. Align the regulator to the fuel tube on the rear of the
stove and push on. Screw on the outer threaded sleeve in a
clockwise direction until tight.
5. Never operate stove with propane cylinder in an inverted
position.
4
Lighting Instructions
Follow the instructions exactly.
1. Check that the burner control knob is turned to the "OFF"
position.
2. DO NOT stand with head, body, or arms over the grill when
lighting.
Lighting The Main Burner
1. Make sure control knob is in the "OFF" position.
2. Push and turn the control knob to the "HIGH" position.
3. If ignition does NOT occur in 5 seconds, turn control knob to
"OFF", wait 5 minutes to allow gas to dissipate and repeat
lighting procedure.
4. Repeat steps 2–3 for lighting the burner. If burner does
not ignite, wait 5 minutes, see "Match Lighting the Main
Burner" section.
5. To turn off, turn the control knob clockwise until it locks in
the "OFF" position. This does not turn off the gas flow from
the cylinder.
Note: If burner does not light or flame is too low, you may
have spider or other insect blockage in burner. See "Burner
Assembly/Maintenance" under Proper Care and Maintenance.
Match Lighting The Main Burner
1. Remove all appliances from the burner to create a free flow
of air.
2. Turn control valve to OFF position.
3. Light match and place it over burner. Slowly turn ON the
control valve. Do NOT stand with head or arms over the
cooker.
4. If ignition does not occur in 5 seconds, turn the burner
control(s) off, wait 5 minutes, and repeat the lighting
procedure.
5. If the burner does not light within the first few attempts
of match lighting, there is a problem with the gas supply.
DO NOT attempt to operate the grill until the problem is
found and corrected. See "Trouble Shooting" section of this
manual.
Turning LP Cooker Off
• Turn the knob to OFF position.
• Unscrew disposable tank.
Dismantling Disposable Propane Cylinder
1. Turn valve to the off position and make sure all flames are
extinguished.
2. Remove the bottle from the regulator by turning counter-
clockwise.
Burner Flame Check
• Light burner; rotate knob from HIGH to LOW. You should see
a smaller flame in LOW position than seen on HIGH. Always
check flame prior to each use. A blue flame with little or no
yellow flame provides the best heat.
Cleaning The Burner
NOTE: Spiders and small insects can spin webs and build
nests inside the burner. This especially occurs in late summer
and fall before frost when spiders are most active. These nests
can obstruct gas flow and cause a fire in and around the
burner and orifice. Such a fire can cause operator injury and
serious damage to the appliance. To help prevent a blockage
and ensure full heat output, clean and inspect burner tube
often (once or twice a month). NOTE: Water or air pressure will
not normally clear a spider web.
WARNING
All cleaning and maintenance should only be done when the
appliance is cool and with the fuel supply turned off at the
LP cylinder. DO NOT clean any part in a self-cleaning oven.
The extreme heat will damage the finish.
Burner Assembly/Maintenance
• Although your burner is constructed of stainless steel, it
may corrode as a result of the extreme heat and acids from
cooking foods. Regularly inspect the burner for cracks,
abnormal holes, and other signs of corrosion damage. If
found, replace the burner.
• DO NOT obstruct the flow of combustion and ventilation
air. Burner tube can become blocked by spiders and other
insects building their nests. Blocked burner tubes can
prevent gas flow to the burner and could result in a burner
tube fire or fire beneath the grill. To clean the Burner
Assembly follow these instructions to clean and/or replace
parts of burner assembly or if you have trouble igniting the
grill.
1. Turn gas off at control knob and disconnect tank.
2. Remove cooking appliance.
3. Remove screw from burner "foot" using a screwdriver.
4. Carefully lift burner up and away from valve openings.
5. Use a narrow bottle brush or a stiff wire bent into a small
hook to run through the burner tube and flame port several
times.
Debris
Note: Wear eye protection when performing procedure 6.
6. Use compressed air to blow into burner tube and out the
flame ports. Check each port to make sure air comes out
each hole.
7. Wire brush entire outer surface of burner to remove food
residue and dirt.
8. Check burner for damage, if any large cracks or holes are
found replace burner. IMPORTANT: Burner opening must
slide over valve nozzle.
9. Orient burner CORRECTLY as shown.
10. Replace screw on burner and follow the "Gas Leak Testing"
section of this manual. Relight burner to verify proper
operation.
Proper Care & Maintenance
• To protect your grill from excessive rust, the unit must be
kept clean and covered at all times when not in use.
• Clean inside and outside of grill by wiping off with a damp
cloth. Apply a light coat of vegetable oil or vegetable oil
spray to the interior surface to prevent rusting.
• The stainless steel exterior surface of your grill, can be
cleaned with stainless steel cleaner.
• Never apply paint to the interior surface. Rust spots on the
interior surface can be buffed, cleaned, then lightly coated
with vegetable oil or vegetable oil spray to minimize rusting.
Cleaning and Maintenance
Correct care and maintenance will keep your appliance
operating smoothly. Clean regularly as determined by the
amount of use. NOTE: Clean the entire appliance each year
5

Publicidad

loading