Campbell Hausfeld XT001000 Manual De Instrucciones página 4

For best output, maintain pressure at the tool of 90 PSI.
u
The longer your air hose the greater the pressure drop from compressor to tool.
u
If you are using a hose longer than 50 feet, consider upgrading to a 1/2 inch ID air
hose to ensure proper tool pressure.
Failure to lubricate and maintain your air tools properly will dramatically shorten
u
their life. Use oil every time you use your air tool to lubricate, clean and inhibit rust
in one step. Campbell Hausfeld sells air tool oil under part number ST1270.
SPECIFICATIONS
Maximum PSI
CFM under load 100% duty
CFM no load 100% duty
SCFM under load 100% duty
SCFM no load 100% duty
Air Compressor Recommendation
Max Torque
Working Torque
Rated RPM (free speed)
Impact Speed (IPM)
Variable Speed
Reverse
Forward
Impact Mechanism Type
Bolt Capacity
Air Inlet
Minimum Hose Size
Anvil
Housing Material
Tool Weight
Tool Length
Tool Height
Tool Width
BEST PRACTICES
2
XT001000
90
3.4 CFM @ 90 PSI
5.6 CFM @ 90 PSI
24.8 SCFM @ 90 PSI
40.1 SCFM @ 90 PSI
8 gallon
160 Ft. Lbs.
0 - 130 Ft. Lbs.
12,000
1,300
Yes
1
3
Twin Hammer
1/2 inch
1/4 inch NPT (F)
3/8 inch
3/8 inch
Composite
2.8 Lbs.
6-1/2 inches
6-5/8 inches
2-1/2 inches