Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Slightly lift up the battery securing tab and remove the battery from
5
the battery socket.
Orient the new battery with the side labeled "+" facing up. Then
6
insert the battery into the socket and release the securing tab.
Do not dispose of this battery along with household waste. Contact your
local waste disposal agency for the address of the nearest battery deposit
site.
Removing and Installing a PCI
Expansion Card
To install a Peripheral Component Interconnect (PCI) expansion card in
the docking device, perform the following steps.
NOTE: Install 3.3-volt (V) or 5-V PCI expansion cards no longer than 10
inches (25.4 centimeters [cm]) in the top slot and install 3.3-V or 5-V PCI
expansion cards no longer than 6.9 inches (15.5 cm) in the bottom slot.
NOTICE: Do not touch or handle anything inside the docking device except
those objects mentioned in the following procedure. If you touch other objects,
you may damage the docking device, and may void your warranty.
Save all files, close and exit all application programs, and exit the
1
operating system.
Turn off the computer.
2
Remove the monitor from the monitor stand. Remove the monitor
3
stand from the docking device.
Undock your computer and leave the eject/locking lever in the
4
unlocked position.
Detach all cables—including the AC adapter cable—from the docking
5
device. Make sure the eject/locking lever is not in the back/locking
position.
Press the latch on the PCI expansion-slot door and remove it. See the
6
following figure.
System In for m a ti o n G ui de
21
Publicidad
Tabla de contenido
