Dell Latitude C/Dock II Expansion Station Guía De Información Del Sistema página 25

Reconnect the cables—including the AC adapter cable—you
12
disconnected in step 5.
Dock your computer.
13
Replace the monitor stand on the docking device and the monitor on
14
the monitor stand.
Turn on the computer.
15
Install the drivers for the PCI card.
16
If a 16/4 Token-Ring PCI Adapter network card came with the docking
device, Dell included a CD containing drivers and installation
instructions.
NOTE: If you are installing network drivers for a 16/4 Token-Ring PCI
Adapter network card, connect the computer to the network before you install
the drivers. Alert your network administrator before you connect the docking
device to a network.
If you are using a PCI card that was not purchased from Dell, use the
drivers and instructions provided by the manufacturer of the card.
NOTE: The 16/4 Token-Ring PCI Adapter network card that Dell installed has
been tested for use with the C/Dock II Expansion Station. Although you can
install other PCI expansion cards, Dell does not guarantee their functionality.
Using the C/Dock II Media Bay
You may use any media device from your computer, such as a floppy drive or
CD drive, in the C/Dock II Expansion Station media bay.
NOTICE: To avoid damaging the docking device or the media device, do not
install any device in the docking device media bay that you do not normally use
in your computer.
NOTICE: To avoid damaging the docking device, do not install the travel
module or battery from the Dell Latitude computer in the docking device media
bay.
To install the computer's media device in the docking device media bay,
perform the following steps.
NOTE: The eject/locking lever must be in the unlocked position before you
install a media bay device.
System In for m a ti o n G ui de
23