Step-by-step installation
Step 1 - Select a location
Location requirements. For the best performance:
•
Install the washer on a solidly constructed floor.
•
Never install the washer on a platform or weakly supported structure.
•
Allow at least 4 in (10 cm) between the washer and the wall.
•
Do not expose the washer to direct sunlight or rain as moisture may damage the electrical
insulation, causing an electrical shock hazard.
•
Provide adequate ventilation.
•
Do not expose to temperatures below 32 °F or 0 °C.
•
Keep away from a heat sources.
•
Provide enough space so that the washer doesn't rest on its power cord.
Step 2 – Insert the baffle board
1. Lay the washer down on its side.
•
Do not lay the washer down on its front or back.
•
While laying the washer down, be careful not to scratch the
surface of the washer.
2. Insert the baffle board into the bottom of the washer along the
guideline.
•
The baffle board can reduce noise while the washer operates.
•
Once the baffle board is installed, do not remove it unless
necessary.
Untitled-2 12
English - 12
2014-05-26
10:51:10