DuPont WFRO60X Serie Instrucciones De Instalación página 10

STEP 7
Connect Tubing (Continued)
IR G P FROM F UCET TO RO SSEMBLY
1A
Locate 1/4" Red Plastic Tubing
P
RO Faucet Body .
2A
Determine length necessary to connect to the drain outlet on the RO Membrane Filter
3A R
Cut 1/4" Red Plastic Tubing square and to length with sharp utility or exacto knife..
4A I
Insert Restrictor into end of 1/4" Red Plastic Tubing
5A
Remove black plug from RO Membrane Filter
pulling plug with other hand. Discard plug.
6A R
Insert 1/4" Red Plastic Tubing
B 2
Filter approximately 5/8" until it stops.
7A
Pull on the 1/4" Red Plastic Tubing
CONNECT 3/8" TUBE FROM REVERSE OSMOSIS F UCET TO DR IN D PTER
1B
Locate the 3/8" White Plastic Tubing
2B
The other end needs to be attached to the collet on the sink Drain Connector
3B T
Cut 3/8" White Plastic Tubing
without loops, dips, low spots or kinks.
4B
Cut the end of the 3/8" White Plastic Tubing
5B
Insert all the way into the fitting approximately 1" until it stops.
6B
Pull on the tube to be sure it is held firmly in the fitting.
CONNECT TUBING FROM RO SYSTEM HE D TO W TER STOR GE T NK
1C
Use the remaining 1/4" White Tubing
to connect the Tank outlet (labeled "T NK") on RO System Head
E
Water Storage Tank .
2C U
Cut 1/4" White Plastic Tubing
3C
Wet the end of tubing and Insert into compression nut of Tank Connector
was connect to tank previously.
4C
Tighten compression nut to secure tubing to Tank Connector
5C
Insert the other end of 1/4" White Plastic Tubing
` System Head (labeled "T NK") approximatley 5/8" until it stops.
NOTE: Tubing lengths should allow for the removal of the assembly from the mount screws
for servicing. If tubing lengths are shortened for neater appearance, it may be necessary to
keep the assembly on the mount screws for service.
NOTE: Codes in the state of Massachusetts require installation by a licensed plumber and do
not permit the use of saddle valves. If you live in the state of Massachusetts, review plumbing
code 248-CMR of the Commonwealth of Massachusetts before proceeding with the
installation.
WFRO60X
R
already attached to the air gap barb on the
R
.
B 2
drain port by pushing on white collar while
all the way into the fitting on bottom of RO Membrane
R
to be sure it is held firmly in the fitting.
T
already attached to the RO Faucet Body
as needed to route in as straight of a run as possible,
T
square with a sharp utility or exacto knife.
U
from Step 6 and determine length necessary
to the
square with a sharp utility or exacto knife.
D
.
U
into the outlet of the RO
7
B 2
.
P
.
K
.
B 2
D
fitting. Which
9
S
T
K
F
U
R
I
4 A
B 2
5 A
R
3C
U
P
U
D
B 2
E
A
R
D
4C
U
E
V4.1