DuPont WFRO60X Serie Instrucciones De Instalación página 9

STEP 6
Connect Tubing
Install 1/4" Plastic Tubing for Water Supply Line from Kitchen Faucet dapter
to System Head Inlet
1
Determine the length of the 1/4" White Plastic Tubing
F
to the Kitchen Faucet dapter . Make sure to allow enough Plastic Tubing to prevent kinking in the line. Do not discard the remaining tubing
for it will be used in Step 7.
2 U
Cut the 6'-1/4" White Plastic Tubing
3
Wet one end of the 6'-1/4" White Plastic Tubing
NOTE: Do not bend or crimp 6-1/4" White Plastic Tubing when inserting.
4
Wet the other end of the 6'-1/4" Clear Plastic Tubing
NOTE: The 1/4" Plastic Tubing does not need to be disconnected for general routine maintenance and filter replacement. However,
Plastic Tubing may be easily disconnected if necessary. Simply turn off the water supply to the Filter System and press in the white collar
around the fitting while pulling the Plastic Tubing out with the other hand
Install 1/4" Plastic Tubing for Water Supply Line from
System Head Outlet to RO Faucet
5
Locate the 1/4" White Plastic Tubing
6
Determine the length necessary to connect to the RO System Head
7
Cut the tubing squarely with sharp utility or exacto knife.
8
Wet the end of the 1/4" White Plastic Tubing
approximately 5/8", until it stops.
WFRO60X
U
that will be necessary to connect the RO System Head
squarely on both ends with a utility knife, making sure not to crimp the Plastic Tubing during cutting.
U
with water and push it into the Kitchen Faucet dapter
U
with water and push it into the RO System Head
S
that is already attached to RO Faucet Body
Outlet (labeled "F UCET").
S
with water and push it into the RO System Head
Inlet (labeled "INLET")
F
approximately 5/8" until it stops.
Inlet approximately 5/8" until it stops.
P
(see page 7 illustration).
Outlet (labeled "F UCET")
8
3
F
4
U
8
6
S
V4.1