Filter Replacement - DuPont WFRO60X Serie Instrucciones De Instalación

QuickTwist ™

Filter Replacement

1
Turn off the cold water shut-off valve to the RO Filter System ssembly.
2 B 1 B 2 B 3
Turn each QuickTwist ™ Filter
to remove it from the RO System Head . Discard the used QuickTwist
NOTE: Place a pan or bucket under the RO Filter System to catch any water drips.
3
Hold each new QuickTwist ™ Filter with the label facing to the left slightly. The two nozzles on top of each QuickTwist
should be toward the back of the QuickTwist
should be out to each side.
NOTE: When viewing the QuickTwist™ RO System from the front, the
positioned on the either side of the center position while the
center position .
4
Lift each QuickTwist ™ Filter straight up into the RO System Head
extended flanges on top of the QuickTwist
5
Turn each QuickTwist ™ Filter from left to right until it stops.
6
Turn on the cold water shut-off valve and the RO Faucet and check for any leaks. If there are leaks, refer to the troubleshooting
information on page 15 of the installation instructions.
7
Pressure Test and purge system per Step 9.
WFRO60X
from right to left until it releases. Gently pull down on each used QuickTwist
™ Filters.
™ Filter. If holding properly, the two extended flanges on top of the QuickTwist
B 1 B 3
and are both WFQTC30001 filters. These filters must be
B 2
is the WFRO1000X or Membrane and must be positioned in the
until the two nozzles seat into the ports and the two
™ Filter are fully engaged into the RO System Head .
X
X
™ Filter
2
™ Filter
™ Filter
3
INLET
4
5
NOTE: Green Membrane Filter should always be in center
position. System may leak if placed in wrong position.
12
INLET
B 1 B 2 B 3
1ST ST GE 2ND ST GE 3RD ST GE
FILTER FILTER FILTER
B 1 B 2 B 3
1ST ST GE 2ND ST GE 3RD ST GE
FILTER FILTER FILTER
B 1 B 2 B 3
Membrane
OUTLET
WFQT270005
OUTLET
V4.1