DuPont WFRO60X Serie Instrucciones De Instalación página 6

STEP 2
Install RO Drain Connector
Be sure that all electrical appliances and outlets are turned off at the
circuit breaker before working in cabinet area.
Drain Connector Installation
Choose the drain outlet location. See Fig. 1 (page 3)
1
Remove protective cover from back of Foam Seal
K
front plate .
2 K
Position the Drain Connector on the sink drain pipe above the drain trap. llow room for drilling. Tighten Screws
M
Nuts securely.
3
Use a battery powered or properly grounded drill. Using the Drain Connector
the wall of the drain pipe. Do NOT penetrate the opposite side of the pipe and be careful not to damage the side of the drain
port fitting.
4
If you wish to install your drain in a remote location refer to page 10.
STEP 3
Install RO Filter System ssembly
The Reverse Osmosis Filter System ssembly Head
C
The Mounting Screws allow you to lift the RO Filter System ssembly without any hardware removal.
1
Choose an easy-to-access area under the sink to mount the RO Filter System Head .
NOTE: To allow adequate space for filter changes, allow a minimum clearance of 4" - 6"below the filter
The Filter System ssembly must be mounted in a vertical position.
NOTE: Mount the Filter System Head to a solid cabinet wall or wall. If a solid surface is not available, use hollow-wall
anchor bolts or toggle bolts (not included) to secure to the wall.
2
Using the Built-in Bracket on the back of the RO System Head
wall surface.
3
Using a 1/8" drill bit, drill two pilot holes for the Mounting Screws
Phillips screwdriver, leaving approximately 3/8" of each Mounting Screw
4
Hang the RO System Head on the Mounting Screws
WFRO60X
WARNING
N.
Knock out center hole and align holes then attach to Drain Connector
K
port as a drill guide, drill a 7/32" hole through
is mounted on Mounting Screws
, mark the holes for the Mounting Screws
C
. Insert Mounting Screws
C
exposed.
C
.
CAUTION
Please wear safety glasses to protect
eyes when drilling.
L
and
C
.
to
the floor.
C
on the
C
into the wall with a
5
2
N
M
K
L
3
C
10-1/2" Minimum Up from Floor. This distance allows for space to change filters.
L
C
V4.1