Setting Up Your Computers - Belkin F5D9630-4 Manual Del Usuario

Setting Up your Computers

In order for your computer to properly communicate with your Router, you
will need to change your computer's "TCP/IP Ethernet" settings to "Obtain
an IP address automatically/Using DHCP". This is normally the default
setting in most home computers.
You can set up the computer that is connected to the ADSL modem
FIRST using these steps. You can also use these steps to add computers
to your Router after the Router has been set up to connect to the Internet.
Manually Configuring Network Adapters in Windows XP, 2000, or NT
1.
Click "Start", "Settings", then "Control Panel".
2.
Double-click on the "Network and dial-up connections" icon
(Windows 2000) or the "Network" icon (Windows XP).
3.
Right-click on the "Local Area Connection" associated with your
network adapter and select "Properties" from the drop-down menu.
4.
In the "Local Area Connection Properties" window, click "Internet
Protocol (TCP/IP)" and click the "Properties" button. The following
screen will appear:
(1)
(2)
(3)
5.
If "Use the following IP address" (2) is selected, your Router will need to
be set up for a static IP connection type. Write the address information
the table below. You will need to enter this information into the Router.
6.
If not already selected, select "Obtain an IP address automatically"
(1) and "Obtain DNS server address automatically" (3). Click "OK".
Your network adapter(s) are now configured for use with the Router.
11 11
1
2
3
4
5
6
7
8
9
10
12