Replacement Parts - Schumacher SPI1 Manual Del Propietário

PROBLEM
The red BAD
BATTERY LED is lit.
16. SPECIFICATIONS
Input Voltage .................................................................. 230V AC~50/60Hz, 0.5A
Output Voltage .........................................6V or 12V, with Auto Voltage Detection
Output Current Rating ...............................................................1A @ 6V and 12V

17. REPLACEMENT PARTS

Ring connectors (quick-connect) .................................................... 2299001950Z
Battery clamps (quick-connect) ...................................................... 3899002636Z
POSSIBLE CAUSE
The battery is sulfated.
Lack of progress is detected
and battery voltage is below
14.2V (for a 12V battery) or
7.1V (for a 6V battery).
The battery's initial voltage
is below 12.2V (for a 12V
battery) or 6.1V (for a 6V
battery) and the total input is
less than 1.5 Ah.
The battery voltage drops
to below 12.2V (for a 12V
battery) or 6.1V (for a 6V
battery) in Maintain Mode.
• 14 •
SOLUTION
The charger is in desulfation
mode. Continue charging
for several hours. If not
successful, have the battery
checked.
The battery may be
overheated. If so, allow the
battery to cool. The battery
may be too large or have a
short circuit. Have battery
checked or replaced.
The battery capacity is too
low, or the battery is too old.
Have it checked or replaced.
The battery won't hold a
charge. May be caused by
a drain on the battery or
the battery could be bad.
Make sure there are no
loads on the battery. If there
are remove them. If there
are none, have the battery
checked or replaced.