Technical Data; Working With The Tool; Care And Maintenance; Ec Declaration Of Conformity - Proxxon GG 12 Manual Del Usuario

Only operate the GG 12 with the voltage supply unit provi-
ded or other PROXXON voltage supply units (NG 2/E or
NG 5/E).

Technical data:

Permanently excited DC motor for 12 - 18 volt
Power rating: max. 25 watt
Nominal current consumption: 0.5 A
Ball bearings
Radial fan for forced cooling
Idle speed: 20,000 rpm
Micro-switch (button) in handle
Housing made of glass-fibre-reinforced polyamide
Power lead (helix cable) with non-interchangeable plug,
approx. 100 cm long
Isolation transformer
For use in dry
environments only
Fuse
Protection class II device
Please do not dispose off
the machine!
Shielded conforming to EC-EMC Directive 89/336.
Noise emission ≤ 70 dB (A).
Fig. 1
Only use inserting tools with a 2.35-mm shaft. Clamp shaft
with pliers and insert into the mount to the stop.
Never overload the tool by pressing too hard. Always
remember that power is provided by the rotational speed
and not the contact pressure.
Note:
Note:

Working with the tool:

Switch on the tool and hold like a pen with a gentle grip.
Rest the lower half of your arm on the table or against your
body. After some practice, we recommend that you work
with templates (available in shops). Simply adhere these to
the rear of the glass with adhesive tape. Always make the
outline first. Use the diamond abrasive pencils to do this.
Then create matt surfaces with the silicon-carbide pencils.
Always remember:
Practice makes perfect. At the beginning, use simple types
of glass (panes or cylindrical glass). Use dark materials
underneath to give a better contrast.

Care and maintenance

Except for occasional cleaning, no special maintenance is
required for your engraving tool. If you follow the instructions
in this User Manual, the tool will reliably and safely provide
you with valuable services for many years.

EC declaration of conformity

Name and address of producer: PROXXON S.A.
Description:
Article No.:
We assume sole liability for ensuring that this product
conforms with the following standards and normative
documents:
EC Machine Guideline
Applicable standards:
EC EMC Guideline
Applicable standards:
EU Low Voltage
Directive
Applicable standards:
Date:
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Equipment Safety Division
6-10, Härebierg
L-6868 Wecker
Engraving tool GG 12 Set
28635
98/037/EEC
DIN EN 60745-1 /12.2003
89/336/EEC
DIN EN 55014-1 / 09.2002
DIN EN 55014-2 / 08.2002
DIN EN 61000-3-2 / 12.2001
DIN EN 61000-3-3 / 05.2002
73/23/EEC
93/68/EEC
DIN EN 61558-1 / 07.1998
DIN EN 61558-1 A1 / 11.1998
DIN EN 61558-1 A11 / 10.2003
DIN EN 61558-2-6 / 07.1998
08.07.04
- 5 -