Connecting Devices - LD Systems LDZONEX1208 Manual De Usuario

BACK
4 3
POWER CONNECTOR AND FUSE HOLDER
3
IEC power connector with fuse holder. The packaging content includes a suitable power cable.
CAUTION: Only replace the fuse with another of the same type and with the same ratings. See information on the housing. If the fuse repeatedly
blows, please contact an authorised service centre.
ON/OFF SWITCH
4
Rocker switch to turn the device on and off.
5 ETHERNET - USB - RESET
Communication expansion card with Ethernet connector, or Ethernet + Dante (64 x 64 I/O) on "D" model, for communication between the ZoneX
processor and the host computer, Micro USB recovery port for firmware recovery and IP reset button.
REMOTE
6
LD Systems remote bus for the integration with future control panels and paging microphones from LD Systems. Please note that this connector
only supports LD Systems remote bus-compatible devices and not Ethernet switch ports!
GPO
7
8 GPO outputs (logic ports) with two selectable modes per output: LED (3 mA) or sink (300 mA). 3-pole terminal blocks (pitch 3.81 mm). Please also
note the connection examples in this user manual (see GPI/O – CONNECTION EXAMPLES)
GPI
8
8 GPI inputs (logic ports), with short to ground activation. 3-pole terminal blocks (pitch 3.81 mm). Please also note the connection examples in this
user manual (see GPI/O – CONNECTION EXAMPLES)
OUTPUTS
9
8 balanced audio outputs. 3-pole terminal blocks (pitch 3.81 mm).
INPUTS
10
12 balanced audio mic/line inputs with switchable 48V phantom power per channel. 3-pole terminal blocks (pitch 3.81 mm).

CONNECTING DEVICES

LD Systems ZoneX DSP processor and other control units run on a network-based infrastructure and are configured and controlled via a computer
with the Xilica Designer software.
PREREQUISITES FOR OPERATION
• Computer
• Network interface (router, PoE switch)
A router is required for the IP address assignment and quick and easy connection to your computer and connected control units. A PoE switch is
required for control units without local power supply.
• Ethernet cable. All wired connections use a standard RJ45 Ethernet cable (Cat 5e or better).
6
5
6
7
Don't connect to any
ethernet switch port!
This port is only for LD
8
Systems remote bus
compatible devices.
9 10