Publicidad
9.5 INSUFFICIENT SUCTION
The recovery tank cover was not correctly tighte-
ned.
Tighten it correctly.
The recovery tank drain hose plug is not perfectly
closed.
Close it correctly.
The suction hose, the squeegee conduit or the
inspection compartment is clogged.
Clean out and remove any obstructions from the
conduits.
9.6 THE BRUSH MOTOR OR THE SUCTION MOTOR
DOESN'T STOP
Stop the machine, cutting off the main power sup-
ply and disconnecting the main battery connector,
and contact the technical service centre.
9.7 THE SQUEEGEE DOESN'T CLEAN OR DRY EFFI-
CIENTLY
The squeegee blades are worn or are dragging solid
dirt.
Replace or clean them.
Remove and wash the squeegee
Drain the recovery tank
Drain, rinse with clean water or sanificate the reco-
very tank
Charge the batteries
Check the acid level in the battery cells (if batteries are
not maintenance-free)
Check the wear of the squeegee rubber blades
Open and clean the suction filter
Remove brushes and check for brush wear, foreign bo-
dies and wrapped belts
Verify the machine general conditions.
Open and clean the solution water filter
Verify that suction hose and conduct are free from
obstructions
Check and clean the pivoting wheels
Check wear and function of traction drive belt or chain; if
necessary, adjust belt or chain tension
Clean the brush plate, squeegee support and
squeegee
Check the lifting/lowering of the brush plate.
Check the lifting/lowering of the squeegee.
Grease the moving parts.
Check the control cable for the opening of the solution
water tap.
Descale water hoses.
The squeegee adjustment is not correct; the
advancement must be exactly perpendicular to the
running direction.
Adjust the squeegee.
The suction hose or the squeegee conduit are
clogged.
Clean out and remove any obstructions from the
conduits.
9.8 THE BATTERY CHARGER DOESN'T WORK
The battery charge doesn't start.
Check that the battery charger is connected to the
battery. Consult the battery charger manual.
9.9 THE BATTERIES DO NOT CHARGE OR DO NOT
HOLD A CHARGE
At the end of the charging process, the battery is
not correctly charged (see the battery manufacturer's
instruction-maintenance manual)
Check the battery charger error message and check
the data indicated on the display (see the battery
charger's instruction manual).
The batteries are new and do not generate 100% of
When
After
needed
every use
X
X
X
X
X
X
X
X
X
X
34
Weekly
Monthly
X
X
X
X
X
X
X
X
X
X
Publicidad
Capítulos
