Dimplex BLF50 El Manual Del Propietario página 16

Fireplace Installation
• Plug in (you may run the
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
• Hard wire the fireplace (rec-
ommended). Follow the hard
wiring instructions on page 9.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
Ensure that the On/Off Switch is set
to the Off position (refer to Opera-
tion section) and that the circuit on
Figure 14
Wall
surface
Mounting hole
16
Mounting hole
which the fireplace is to be installed
has the power cut off at the service
panel until installation is complete.
3. Lift fireplace and insert into
opening. The fireplace's
mounting trim should be flush
against the wall (Figure 14).
4. Use bubble level (supplied) to
level the fireplace within the
framing. Adjust as required.
5. Drive four supplied mounting
screws through the four mount-
ing holes located on the inside
surface of the fireplace chas-
sis, into wall studs (Figure 14).
6. Refer to Front Glass Installa-
tion section, page 17 for final
installation procedures.
Figure 15
Front glass
assembly
Front tray
www.dimplex.com