In-Wall Recessed Installation - 2X4 Framing - Dimplex BLF50 El Manual Del Propietario

Fireplace Installation
Figure 10
12. Carefully replace and install
partially reflective glass and
glass brackets using screws
from step 1.
13. Refer to Front Glass Installa-
tion section, page 17 for final
installation procedures.
In-wall Recessed Installa-
tion - 2x4 Framing
CAUTION: Two people may
be required for various steps
of this procedure.
1. Prepare a wall with a framed
opening of 46 ½ in. (118.1
cm) wide x 16 ½ in. (42 cm)
high (Figure 10).
!
NOTE: The sizing has allowed
14
2 x 4 Framing
for 1/4 in. (6.4 mm) around the
fireplace insert for ease of instal-
lation. This fireplace does not
require any additional venting.
2. Choose your method of sup-
plying power to the unit:
• Plug in (you may run the
power cord out of the framed
wall opening to an existing
outlet or install an outlet on
a nearby wall stud within the
wall).
• Hard wire the fireplace
(recommended). Follow the
hard wiring instructions on
page 9.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
Figure 11
Mounting
holes
www.dimplex.com