Hardwire Installation; Wiring - Dimplex BLF50 El Manual Del Propietario

Fireplace Installation

Wiring

Hardwire Installation

The fireplace is packaged with a
two prong plug installed for plug-
in convenience. Hard wiring the
fireplace is also an option for any
installation.
WARNING: Do not attempt to
wire your own new outlets or
circuits. To reduce the risk of
fire, electric shock or injury to
persons, always use a licensed
electrician.
WARNING: Ensure that the
On/Off Switch is set to the Off
position (refer to Operation
section) and that the circuit
on which the fireplace is to be
installed has the power cut off at
the service panel until installa-
tion is complete.
1. Remove the partially reflective
glass from the fireplace:
• Lay fireplace on its back.
M
M
RL3
RL2
RL1
• Remove two Phillips screws
from each of the two glass
brackets (Figure 2).
• Remove glass brackets.
• With one hand keeping pres-
sure on the partially reflective
glass, tilt the fireplace upright
and slightly forward to allow
the partially reflective glass to
fall out of the inside framing.
Figure 2
Glass Bracket
L1
120V~
60Hz
N N
N
N
Bracket Screws
Partially
Reflective Glass
9