Adjustment Step; Program The Travel - Craftsman CMXEOCG231 El Manual Del Propietario

ADJUSTMENT STEP 1

PROGRAM THE TRAVEL

1. Press and hold the Adjustment
Button until the UP Button
begins to flash and/or a beep
is heard.
2. Press and hold the UP Button
until the door is in the desired
UP position. NOTE: The UP and
DOWN Buttons can be used to
move the door up and down as
needed.
3. Once the door is in the
desired UP position press and
release the Adjustment
Button. The garage door
opener lights will flash twice
and the DOWN Button will
begin to flash. IMPORTANT
NOTE: For one-piece door
installations refer to page 28.
4. Press and hold the DOWN
Button until the door is in the
desired DOWN position. NOTE:
The UP and DOWN Buttons can
be used to move the door up
and down as needed.
5. Once the door is in the
desired DOWN position press
and release the Adjustment
Button. The garage door
opener lights will flash twice
and the UP Button will begin
to flash.
Without a properly installed safety reversal system, persons (particularly
small children) could be SERIOUSLY INJURED or KILLED by a closing garage
door.
Incorrect adjustment of garage door travel limits will interfere with proper
l
operation of safety reversal system.
After ANY adjustments are made, the safety reversal system MUST be
l
tested. Door MUST reverse on contact with 1-1/2" (3.8 cm) high object (or
2x4 laid flat) on floor.
6. Press and release the UP
Button. When the door travels
to the programmed UP
position, the DOWN Button
will begin to flash.
7. Press and release the DOWN
Button. The door will travel to
the programmed DOWN
position. Programming is
complete.
* If the garage door opener lights are flashing 5 times during the steps for Program
the Travel, the programming has timed out. If the garage door opener lights are
flashing 10 times during the steps for Program the Travel, the safety reversing
sensors are misaligned or obstructed (refer to page 27). When the sensors are
aligned and unobstructed, cycle the door through a complete up and down cycle
using the remote control or the UP and DOWN buttons. Programming is complete.
If you are unable to operate the door up and down, repeat the steps for
Programming the Travel.
29