Features; Using Your Garage Door Opener; Using The Door Control - Craftsman CMXEOCG231 El Manual Del Propietario

FEATURES

Your garage door opener is equipped with features to provide you with greater
control over your garage door operation.
REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener has already been programmed at the factory to operate
with your remote control, which changes with each use, randomly accessing over
100 billion new codes.
Accessories MEMORY CAPACITY
Remote Controls Up to 8
Door Controls Up to 2 door controls.
Keyless Entries Up to 1
THE SAFETY REVERSAL SYSTEM
When properly connected and aligned, the safety reversing sensors will detect an
obstruction in the path of the infrared beam. If an obstruction breaks the infrared
beam while the door is closing, the door will stop and reverse to full open
position, and the opener lights will flash 10 times. If the door is fully open, and
the safety reversing sensors are not installed, or are misaligned, the door will not
close from a remote control. However, you can close the door if you hold the button
on the door control or keyless entry until the door is fully closed. The safety
reversing sensors do not effect the opening cycle.
ENERGY CONSERVATION
For energy efficiency the garage door opener will enter sleep mode when the door
is fully closed. The sleep mode shuts the garage door opener down until activated.
The sleep mode is sequenced with the garage door opener light bulb; as the light
bulb turns off the sensor LEDs will turn off and whenever the garage door opener
lights turn on the sensor LEDs will light. The garage door opener will not go into
the sleep mode until the garage door opener has completed 5 cycles upon power
up.
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged
in; power is restored after interruption, or when the garage door opener is
activated. The lights will turn off automatically after 4-1/2 minutes. An
incandescent A19 light bulb (100 watt maximum) or for maximum energy efficiency
a 26W (100W equivalent) compact fluorescent light (CFL) bulb may be used.

USING YOUR GARAGE DOOR OPENER

The garage door opener can be activated through a wall-mounted door control,
remote control, or wireless keyless entry.
When the door is closed and the garage door opener is activated the door will
open. If the door senses an obstruction or is interrupted while opening the door
will stop. When the door is in any position other than closed and the garage door
opener is activated the door will close. If the garage door opener senses an
obstruction while closing, the door will reverse. If the obstruction interrupts the
sensor beam the garage door opener lights will blink 10 times. However, you can
close the door if you hold the button on the door control or keyless entry until the
door is fully closed. The safety reversing sensors do not affect the opening cycle.
The safety reversing sensor must be connected and aligned correctly before the
garage door opener will move in the down direction.

USING THE DOOR CONTROL

SYNCHRONIZE THE DOOR CONTROL: To synchronize the door control to the garage
door opener, press the push button until the garage door opener activates (it may
take up to 3 presses).
Push Button
32