Remote Control; To Erase The Memory; Erase All Remote Controls And Keyless Entries - Craftsman CMXEOCG231 El Manual Del Propietario

REMOTE CONTROL

Your remote control has been programmed at the factory to operate with your
garage door opener.
Older remote controls are NOT compatible. Programming can be done through the
learn button on the garage door opener. If your vehicle is equipped with a
®
Homelink , you may require an external adapter depending on the make, model,
and year of your vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
1. Press and immediately release the Learn button.
2. Remote Control: Press and hold the button on the remote control that you
wish to use.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your
choice on the keyless entry keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the
code has been programmed. Repeat the steps for programming additional remote
controls or keyless entry devices.
1
LEARN LED
2
OR
?
LEARN
Button
? ? ?
PIN

TO ERASE THE MEMORY

ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES

1. Press and hold the LEARN button on garage door opener until the learn
LED goes out (approximately 6 seconds). All remote control and keyless
entry codes are now erased. Reprogram any accessory you wish to use.
ERASE ALL DEVICES (INCLUDING myQ
1. Press and hold the LEARN button on garage door opener until the learn
LED goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the learn LED
goes out. All codes are now erased. Reprogram any accessory you wish to
use.
33
®
ENABLED ACCESSORIES)